An analysis of oil leakage in diesel generator sets

Diesel generator set is like sometimes spills occur, especially some domestic brands of diesel generator sets, oil leakage often, then how do we analyze the oil spill site, and to solve this problem, the diesel generator manufacturers to introduce you the following solutions: diesel generator oil spill is like sometimes arise, especially One of these domestic brands of diesel generator sets, oil leakage often, then how do we analyze the oil spill site, and to solve this problem, diesel generator manufacturers to introduce you to the following solutions:

1, purchased or homemade paper pad substandard quality requirements, such as thickness is not enough, or properly maintained, buckled and deformed, or assembly not clean, stained with dust and impurities, which are the cause of the oil spill is generated.

2, the oil pressure is too high, causing static joints oil leakage.

3, static joints quality itself, which is mainly determined by the processing equipment itself, accuracy and storage conditions. If the high precision equipment, static joints flatness, roughness can reach the drawing design requirements, and pay attention to prevent damage during storage and transportation, etc., it is not difficult to achieve static joints completely sealed. However, due to the level of accuracy and process equipment One of these manufacturers is still relatively low, storage conditions and management level is not guaranteed and no bump scratch.

4, when poor maintenance technique. One like the current diesel generator to self-study mainly because of repair techniques can not keep up, often self-study in one way or another problem, especially when dismantling the machine pay attention to methods, the lack of special tools to make parts deformation, or even damaged. Since the deformation of parts, causing oil spills. Currently, One like disassembling method using the main bearing cover mounting bolts are screwed into the main bearing cover diagonal removable internal thread, top of the main bearing cap. In the disassembly process is very difficult to synchronize the two bolts progress, which is caused by the deformation of the main bearing cap main reason.

What measures can prevent it?

1, sealing adhesives, can play a sealed, leak-proof, secure and plugging the gap effect, to prevent leakage of oil purposes.

2, the demolition process should take synchronous operation of law, as they both operate, try to make a uniform twist bolts.

3, where conditions permit puller as far as possible, in order to solve the synchronization problem fundamentally.
3, where conditions permit puller as far as possible, in order to solve the synchronization problem fundamentally.